Filter Cap

Filter Cap

Although the minimum standards for city water, many have chosen to filter their drinking water anyway. After all, just because the water tastes good and has no smell, does not mean it is pure. Of course, the best way to know if the water is safe is to take a sample to a testing center. But even if it passes this test, you may want to filter, just to be sure.

Why spend a lot on a filter unit when you can do yourself? Below is a plan to make low-cost filter carbon water that will guarantee that drinking water safer.

The supplies you need are: a length of 2 1 / 2 inches target = "_blank" title = "Description Look for PVC> PVC pipe, maybe a foot or more, a 2 1 / 2 inch PVC CAP, a piece of hose vinyl from the unit to the storage tank, the supply of activated carbon, some of sealant, and an unused coffee filter paper. Also need a drill and a bit large enough for the vinyl tubing to fit into the hole.

First, drill a hole in the PVC cap and insert the hose into the same. Silicone Sealant can be used to ensure no leaks. Insert the plug on one end of the PVC pipe. Then fold the coffee filter paper and inserted in the bottom of the PVC pipe so that it covers the hole in vinyl tubing. This keeps the carbon from the blockage of the hose.

Now you are ready to add the description of carbon> carbon for PVC. fill it as complete as possible. The more carbon you use, more filtering will place. Keep the unit upright PVC and fill with water. Be sure the vinyl tubing is designed in a clean storage container. As the water flows by PVC, carbon remove impurities, supply of clean water. Note: you may want to discard the first batch, as it cleans all parts of your unit.

Of course, I will not be there to hold this unit every time you water. A simple post can be done with two 4-inch squares 3 / 4 inch pine, a wood and a wooden upright, taller than the PVC pipe. Drill a hole in the center of each of the 4-inch square pieces of sufficient size PVC to happen. Then tie these parts into the vertical position attached to the base and insert the filter. A screw can be used to keep the PVC slip.

Your unit is ready for use. Remember, the more carbon have been in PVC pipe, more filtration is carried out. Therefore, more is better. Also, make sure to replace coal and periodically clean the inside of the PVC, while it is empty. The frequency will depend on the amount of water through the filter unit.

Obviously, this unit is small and only sufficient for drinking water. But if it keeps the whole filter and store the filtered water, have enough to keep your thirst quenched.

About the Author:

If this sounds like too much work, consider the Berkey Water Filter line. The Black Berkey purification elements that ship with the Berkey Filters can be re-cleaned with just a brush to provide up to 6,000 gallons of purified water as well as being very easy to set up and maintain.

Article Source: ArticlesBase.com - Steps to Build Your Own Gravity Water Filter